This website uses cookies to implement certain functions. If you use this website you agree to our Privacy Policy.
News and Information about the Test of Electronics in Research & Design, Production, Maintenance, and Installation.  

Newsletter

Register to our newsletter
Every two weeks -
all news at a glance
captcha 

New Generation of high speed Flying Probe PCB Testers

atg-A8a06 January 2015 - atg Luther & Maelzer released a new generation of automated high speed flying probe PCB Testers. The new A8a test system combines the flexibility of flying probe testers with high throughput. The A8a provides significant cost advantages compared to fixture testers for small and medium batches and fully meets the requirements for the electrical test of HDI products.

The A8a is equipped with eight test heads and four cameras for optical alignment. The A8a is able to test pad sizes down to 35 micron. Testing HDI products for smart phones, tablet and PC motherboards up to a test area of 18.0” x 12.0” on the A8a, it also eliminates limitations of test point density or fine-pitch contacts.

The A8a features embedded component test or a 4-wire Kelvin measurement with an accuracy of +/- 0,025 mOhm.

The A8a is provided with a separate good and bad board stacker. The bad boards can be optionally labeled by a 2D-Code. The 2D-code indicates the reference between the boards and the corresponding fault file. This way handling failures by an operator are eliminated.

The A8a is prepared for lights out operation. With the feeder capacity of 390 mm it is possible to test 650 boards with a thickness of 0.6 mm at one time. This capacity guarantees an operator-free test over the whole night shift.

To fully meet the speed expectations the key feature of the A8a is a new dual shuttle system, which reduces the product exchange time to less than 4 seconds in automation mode. In combination with the fast test speed of up to 140 measurements/second the A8a will give customers a competitive test solution for batches up to 5000 boards. A typical cycle time of a 4-up smart phone board is about 2 minutes.

Peter Brandt, Sales Manager Europe and Japan, explains: “The main advantage of the A8a for PCB producers is the significant cost savings compared to a fixture tester. The high costs of dedicated fixtures, which can range from $10-30K per fixture, justify the electrical test with a high speed flying probe system.”

www.atg-LM.com/

www.Xcerra.com/



Upcoming Events

ECOC 2017
Gothenburg (Sweden)
17 to 21 September 2017
enova 2017
Paris(France)
19 to 21 September 2017
EUROPEAN MICROWAVE WEEK 2017
Nuremberg (Germany)
08 to 13 October 2017