This website uses cookies to implement certain functions. If you use this website you agree to our Privacy Policy.
News and Information about the Test of Electronics in Research & Design, Production, Maintenance, and Installation.  

Newsletter

Register to our newsletter
Every two weeks -
all news at a glance
captcha 

General T&M

Current Probes to measure High Frequency Motor Drive Common-Mode Currents

PEM CMC10 May 2016 - Power Electronic Measurements (PEM) Ltd. lauched the new CMC series of current probes based on Rogowski technology. The probes enable engineers to assess the magnitude of the threat posed by hf common-mode currents, that can damage motor bearings and interfere with nearby electrical equipment. The current measurements can help determine suitable corrective action, such as fitting brushes, insulated bearings, or choke coils, and with further measurements assess the effectiveness of the chosen remedy.

The screened coils have excellent immunity to voltage disturbances and a low frequency (-3dB) bandwidth that attenuates unwanted 50/60Hz magnetic fields while maximising the SNR of the measurement of the high frequency common mode currents. Available in coil sizes from 300 to 1000mm, and longer if required, making them ideal for use with a wide range of motor shafts. Even with a coil circumference of 1000mm the CMC probes can achieve a high frequency (-3dB) >10MHz.

The probes are available in three sensitivity grades for measuring bearing currents up to 37.5A, 75A or 150A peak. The peak detected current corresponds to a maximum output voltage of ±7.5V when connected to an oscilloscope input via the BNC output provided.

www.pemuk.com/



Upcoming Events

EMC Europe 2017
Angers (France)
04 to 08 September 2017
EPE '17 ECCE
Warsaw (Poland)
11 to 14 September 2017
ECOC 2017
Gothenburg (Sweden)
17 to 21 September 2017

Social Media

twitter_follow_420x50px